Forum Replies Created

Viewing 16 posts - 1 through 16 (of 16 total)
  • slowjig59
    MN
    Posts: 21
    December 16, 2022 at 6:08 pm #2167225

    another photo

    Attachments:

    1. 20221206_154348-scaled.jpg

    slowjig59
    MN
    Posts: 21
    May 15, 2020 at 8:51 pm #1942742

    Ok, thanks Brush length is 78″ and brush height is 18″

    slowjig59
    MN
    Posts: 21
    November 24, 2018 at 4:25 pm #1812274

    A couple more photos

    Attachments:

    1. DSCN0064.jpg

    2. DSCN0066.jpg

    slowjig59
    MN
    Posts: 21
    November 24, 2018 at 4:17 pm #1812271

    Here is a picture, that did not upload when I first posted it.

    Attachments:

    1. 002.jpg

    slowjig59
    MN
    Posts: 21
    January 3, 2017 at 4:11 pm #1661841

    Hard to find, but Thorne Bros has both sizes #5 & #4’s

    slowjig59
    MN
    Posts: 21
    January 1, 2017 at 5:42 pm #1661340

    Better watch again, I think they were the new Slab Raps
    James has been using these the last couple shows, Mike
    was using a ripping rap and switched over to a Slab Rap

    slowjig59
    MN
    Posts: 21
    November 1, 2016 at 7:16 pm #1648363

    I have a 2006 WX1880 tandem trailer and changed out my tongue jack with just the next size up. Fulton has one that is a direct bolt on to the one you have. I think it is a 1500 lb. one . I think I got it at Hannay’s in mpls.Also, changed out the smaller winch on trailer too.

    slowjig59
    MN
    Posts: 21
    July 13, 2015 at 8:47 am #1554399

    I tried it and 5 came up to $105 shipped.There was no promo code either
    what gives

    slowjig59
    MN
    Posts: 21
    April 23, 2015 at 6:32 pm #1537313

    was this for a skeeter seat? If so $50

    slowjig59
    MN
    Posts: 21
    February 21, 2014 at 12:50 pm #1390586

    WX 1900 same boat,only it has snap in carpet

Viewing 16 posts - 1 through 16 (of 16 total)