If you wanted mapping on both units then no the dealer didn’t take you. Helix units don’t share mapping. If you want mapping on each unit they each need their own chip.

gimruis wrote:

<div class=”d4p-bbt-quote-title”>tbruno wrote:</div>
she will do 40 to 41 mph (GPS Speed) on relatively flat water, and about 38 mph with two of us in the boat with the stock prop

I feel like you should be getting better speed with a 115. I have a 75 and can go that fast using an aluminum prop.
[/quoits

Speed depends on a lot of factors. My “Slight” addiction to tackle and gear may have something to do with the top end speed and I’m not a little guy either.

nord wrote:

tbruno, how does the 115 Yamaha push your Voyageur?

My 115 works great on that boat. By myself fully loaded with all my gear, and I carry alot of stuff onboard, she will do 40 to 41 mph (GPS Speed) on relatively flat water, and about 38 mph with two of us in the boat with the stock prop.

This is what my set up looks like on my Alumacraft Voyageur. I built a cabinet under my rear flip down platform and mounted a series 24 deep cycle in the center (there is enough room for a series 27 when I need to replace it). I bought a Blue Seas charging system that charges the house battery with my outboard alternator. I run 2 Helix 9’s, an old 899 for mapping, a mega 360, and a deckhand 40 off the house battery and always have had enough power. I run from spot to spot quite a bit so that probably helps to keep the house battery well charged. All of the other accessories run off the cranking battery, (lights, bilge, live well, radio, and networking switch). I do keep a set of jumper cables in the boat in case the cranking battery would ever go dead.

Attachments:

1. 

   20240321_142123-scaled.jpg
   

2. 

   20240321_142116-scaled.jpg
   

3. 

   20240321_142103-scaled.jpg
   

4. 

   20240321_141957-scaled.jpg
   

I would try to run it out of the water. Just start the unit and let it power up. then push the power button and turn the sonar “off” and let the unit run to see if it goes black with the sonar off after awhile. You will still have other views that can be seen with the sonar off. You could also put it in simulation mode and let it run for awhile to see what happens.

I have a Voyageur side console with a Shorelander roller trailer with the Drotto and it works great. Just follow the instructions for installing and you should have no issues. I moved my winch post so the rollers were in the same position under the boat as original as adding the Drotto will keep the boat back further on the trailer if you don’t adjust the winch post.

One of the most challenging questions to answer when you are purchasing a new boat that’s for sure. I think both have their advantages and disadvantages. I have a Shorelander roller trailer with a Drotto latching system and really like that set up for me personally. The roller trailer works well for loading and unloading at shallow landings, but sometimes can be more difficult to get on straight if your trailer depth is a little off. The drotto makes unloading and loading very easy, weather alone or with someone. With two of us, one backs in and by the time he stops and puts in forward I have unhooked the safety chain and pulled the release and the boat is off the trailer in a few seconds. Loading isn’t quite as fast but usually in and out of the ramp in less than two minutes.

Is your unit connected directly to your battery or running with other accessories? How old is your battery? Use a voltmeter to check your actual voltage at the battery and at the unit. Make sure all your wiring is in good shape with clean and tight connections especially the ground side. I have never had or heard of this being a common thing with Bird’s but does not mean it doesn’t happen. My last two new units worked perfect right out of the box with no issues but, mine are all individually wired circuits direct to a house battery with proper gauge wire. If the problem continues call Humminbird customer service (None Better) and they will give you some things to check, which will likely include what I mentioned above.

I have Onyx Am 24’s. Have had them for about seven years already with no issues. They take up a lot less space in storage and are comfortable to wear, even when it’s ninety degrees outside. As others have said after you put one on you forget your even wearing one. They are easy to maintain and recharge. A three pack of new dissolvable bobbins for them are about $31.00 on Amazon and the last ones were dated for three years. I think for less than $4.00 a year for maintenance and the comfortability they are well worth it. Mine have a D-ring on the right side to attach your emergency cutoff switch umbilical cord also.

Always check and maintain your vehicles cabin air filter. They trap all types of contaminants and materials that can keep your HVAC system from not functioning properly and can cause some pretty funky smells as they start to decompose.

x2

Not sure about changing employers. I recently retired while undergoing rehabilitation for a work-related injury and they are continuing to cover any medical expenses until I’m released by my doctor. Have to take a return-to-work document into my previous employer after every visit even though I’m retired.

Chec out, RoosterWrap cell phone safety harness.

Ok, my poor, at best, computer skills are showing. I will try to answer questions that were asked about my Eagle Claw Rod Case in the main forum. I used brass plumbers chain so as to prevent any rust getting on my equipment. I attached the chain to the case with #6 stainless steel machine screws and Nylock nuts as per photos. The boxes that I discovered work the best are the Flambeau 3300 Zerust Max Series boxes that I bought at Walmart for under $5.00 each. I left the display hanger on the end of the box to apply a “spring” pressure between the box and the case. The boxes fit loose side to side in the grooves which I eliminated by using some 1″ furniture glides from Menards and placing one on each side of the slot on both ends of the slot. this applies enough pressure to hold the boxes from moving side to side and falling against the rods when transporting your case. I actually pushed the boxes into place, held the box upside down and shook it and none of the boxes moved, even my box of tungsten jigs and spoons.

Attachments:

1. 

   20210221_132945.jpg
   

2. 

   20210221_132956.jpg
   

3. 

   20210221_133012.jpg
   

4. 

   20210221_133022-1.jpg
   

5. 

   20210221_133325-1.jpg
   

6. 

   20210221_133340-1.jpg
   

Flambeau 3300 Zerust max series boxes fit perfectly length wise. Then I bought felt furniture slides from Menards and put one on each side of slot and theyfit firmly into the space.

Attachments:

1. 

   20210221_133325.jpg
   

2. 

   20210221_133340.jpg
   

I used #6 machine screws with nylock nuts to attach it to the case.

Attachments:

1. 

   20210221_133022.jpg
   

For good rod protection I would recommend a hard side case. I like my Eagle Claw case it protects my rods and has plenty of room for tackle storage all at a good price point. I started out with bags, then upgraded to a soft side case, and now to the hard side case.

Attachments:

1. 

   20210215_164649-1.jpg
   

Got a new StrikeMaster Surface Suit delivered free to my doorstep last week from Cabelas. Regualrly $199.99 each piece on sale for 139.99 each. This week Fleet Farm has all ice fishing clothing and accessories 30% off. Just got the wife a pair of Clam Women’s Cold Weather Gloves for $28.00. Also alot of open water and hunting clothing on clearance.

x2 on Kahtoolas

To each his own as far as what technology to use. Some people cant afford to keep up with technology even if they would like to. I could afford the “latest and greatest technology”. At least it would be until next year. However, my “Old Technology” still does everything I need it to do for ice fishing. It shows me depth, bottom composition, and fish location. Just fished with my grandson today with my “New” 12year old FL-18 right next to my “Old” 20 year old FL8-SLT without any interference and we had no problem seeing or catching fish. The bluegills, crappie, perch, and walleye don’t care about what technology I am using. Maybe they should t hough.

Are the trailer and the truck both level when hooking them up? I have problems sometimes when the rear of my Suburban is on a down hill slope when hooking up to my boat or small utility trailer. Sometimes take 2 or 3 attempts to get the coupler to seat onto the ball. Also check to see if the spring on the bottom side of the coupler lock is not broken, it helps to keep the latch vertical in the coupler. A broken or bent spring could cause the latch to catch on the ball as you are lowering the trailer onto the ball.

From Humminbird, you can extend power wires with 18awg wire..

I just keep mine on the concrete floor in the basement. They usually last about 4 months or until used up. Have to be sure to check them often and remove dead ones or it will kill the others.

Small meat markets around my home usually have local farm suppliers and only can process so many animals in a day regardless of the amount of animals needing to go to slaughter. If anything the prices will increase some due to supply and demand.

A good practice for something that is usually neglected or overlooked. Just looked all mine over today when I loaded the boat.

I tie my own with Du Bro slip bobber knot material and always use mono on my reels for slip bobbers. Have not been able to find any other pretied knots that last for any amount of time without fraying. The Du Bro knots last me a couple of days at least.

I have a 2014 Traverse AWD and it has no problem with my 17.5 Alumacraft with a 115 hp engine.Enough power for good acceleration and never had problem with braking control yet.

It states that it’s a travel advisory and unnecessary travel is discouraged. I don’t think they will be stopping people driving to check where they came from or where they are going. I have been told by law enforcement personal that they are to limit interaction with people if at all possible to prevent becoming infected.(i.e. traffic stops for minor violations or equipment violations) Have heard other people saying you need paperwork to travel to work and that is false also.

Just spent over 100.00 dollars at my local Walmart last night. Bought Custom jigs and spins Chekai tungsten jigs. Slender spoons, Northland forage minnows, Buckshot rattle spoons, and both Trilene fluorocarbon and mono line for just short of 1/2 off regular price. The same with their Beaver Dam Glass Noodle Rod Combos. A little early Christmas shopping for the Son-in-law who is just starting out ice fishing and for my 6 year old grandson. A couple of years ago got a $150.00 bass rod and reel for $30.00. Just need to be there at the right time as the stuff goes fast.
.

Where I work, I get five weeks of vacation with the ability to carry over one week, eight paid holidays, two personal days, and can build two weeks of comp time per year. We earn 8 hours of sick leave per month and can use 40 hours per year of that as family sick leave for wife, children and parent illnesses, appointments, etc.