Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • riverdawg
    Posts: 12
    June 29, 2004 at 6:46 pm #310519

    By the way, I caught this fish on an 1/8 ounce jig with a twister tail while fishing for walleyes using a light spinning rod and 8 lbs test. It took about a half hour to land it. What a blast!

    riverdawg
    Posts: 12
    December 23, 2003 at 3:26 pm #286219

    Count me in … if it’s not too late.

    riverdawg
    Posts: 12
    September 19, 2003 at 8:45 pm #276777

    Pick me, Pick me – thanks James, good idea

    riverdawg
    Posts: 12
    May 22, 2003 at 7:10 pm #267211

    I used the ramp at Frontenac last saturday with no trouble. Water’s come down a bit since then, so you should have no trouble.

    riverdawg
    Posts: 12
    May 7, 2003 at 5:10 pm #266069

    I am not sure, I believe it is. How can I tell?

    riverdawg
    Posts: 12
    May 7, 2003 at 12:20 pm #266042

    Care to elaborate on why I shouldn’t run over 3/4 throttle? Do you have some personal experience with this motor?

    riverdawg
    Posts: 12
    April 28, 2003 at 5:37 pm #265255

    So far I have only fished from the Hay Creek area up to the dam. I will be out this weekend and it is time to branch out and start looking downriver. Does anyone have any recommendations on where to begin? Is it too early to check out the Maiden Rocks flats with cranks? How ’bout up a little further toward the head of the lake? Has anyone used the launch up around Frontenac? I know I have asked a lot of questions, but as I get more familiarized with this fishery, I promise to contribute back to the forum as well. Thanks to all for the jump start!

    riverdawg
    Posts: 12
    April 24, 2003 at 3:54 pm #265024

    Thanks to all for the tips. I appreciate your responses.

Viewing 8 posts - 1 through 8 (of 8 total)