Forum Replies Created

Viewing 30 posts - 1 through 30 (of 190 total)
  • redrnger
    Posts: 216
    #1588845

    The Lazy IKES have been made by the thousands over the years not much value to them unless there pristine condition with original box. Cisco Kids are the same.Fish them or hang them up to look at.

    redrnger
    Posts: 216
    #1530171

    Randy did the gearing in your head unit break that you need these parts,because thats what has happened to mine and I think those are the same as I need to fix them.

    redrnger
    Posts: 216
    #1512446

    bag21.6 big fish8.3

    redrnger
    Posts: 216
    #1497648

    WOW,those are some nice gills.

    redrnger
    Posts: 216
    #1488670

    Generally,spring and fall the fish are shallow,either spawning or putting the feed bag on for the winter.Summer time weed edges and points close to deep water with inside turns on them will usually hold them.Really depends on fish species in the time of year and where the pray that there feeding on is located.

    redrnger
    Posts: 216
    #1478340

    Try using the new spray scent killers for dear hunters.Works for B-O so should work for cigarette smoke.lol

    redrnger
    Posts: 216
    #1466368

    Brian how do you fill the co2 with air from a compresser.I did not think you could refill ones that had gone off.

    redrnger
    Posts: 216
    #1463810

    While I try to clean my boat as mush as possable, when you pull a boat out at a ramp the weeds are going to be caught between the boat bunks and rollers and no amount of pulling are going to remove them.They are there until you remove the boat from the trailer.They are going to have to put something at the ramps to lift the boats off the trailers to remove all the weeds.So even though your removing the weeds you see your still carrying them when you leave and are no better than anyone else.There just out of your site.Mute arggumant….

    redrnger
    Posts: 216
    #1460867

    Man the sounds of those dogs baying really brought back some good memories of hunting with my brothers and our baegles.Nice vid and welcome to the site.

    redrnger
    Posts: 216
    #1460853

    Sorry my bad.I see your asking about Lowrence locators.

    redrnger
    Posts: 216
    #1460851

    If you belong to facebook go to groups and join the Hummingbird group they have some techs on there that will answer most of your questions.Very good group.

    redrnger
    Posts: 216
    #1460284

    Looks like hes got some of your spam in his mouth.

    redrnger
    Posts: 216
    #1457175

    They are some nice looking baits.

    redrnger
    Posts: 216
    #1454812

    What part of the Wisconsin or area.

    redrnger
    Posts: 216
    #1414547

    Boy the knats are as irritating as the mosquitoes and are everywhere.

    redrnger
    Posts: 216
    #1413427

    The last 3 weeks have been on fire on the Lake.I fish it most week days and getting a limit is not hard.Drifting split shot rigs or jigs with worms or leechs on flats in 4 to 8 feet of water has been the ticket with plenty of overs and slot fish as Randy said.I have not tried the trolling or crank bait casting as the other bite has been going so good.I live on the lake during the summer and it has been a number of years since we have had a bite this good for this length of time.The crappies have been going good and the gills are moving shallow.I took the wife out Friday and got a good batch we ate that nite beer batter fried.The large white bass should start hitting on the reefs soon casting tail spinners and sonar type lures.I can not wait to try the ripping raps on them.As has been said the bite is on.

    redrnger
    Posts: 216
    #1410401

    The resivoir in the cowling is not leaking but I will check batt connections.I still think might be the thermostats.Will let you know when I find out.

    redrnger
    Posts: 216
    #1407965

    Take mine home from a hospital visit.I paid for it.

    redrnger
    Posts: 216
    #1405942

    Really nice color,would buy it in a ring worm too.

    redrnger
    Posts: 216
    #1405236

    I like the rattling rouge in the suspending model in the blue back silver side orange-red throat or clown.I like the kvd square bills too both the way they run and price wise.

    redrnger
    Posts: 216
    #1405206

    Send the 1st one a registered letter and you will have proof of trying to contact her.

    redrnger
    Posts: 216
    #1405060

    I just had mine done and you fill them all the way.I use 50 wt Valvoline oil to .Never a problem in 14 yrs.

    redrnger
    Posts: 216
    #1404854

    I had a tiller with a 25 on it and was going down river just above idling speed when, I hit a log under water and it jerked the handle to the left.When it jerked it caused me to turn the throttle to the fast position raising and spinning the boat while flipping me out on the right back.I went under water and when I came up the boat was in a spin with the motor coming right at me.I was able to grab the boat on the left side on the back by the motor and the prop hit me in the right side.I was going threw where a old rail bridge had been taken out and made it to a bridge abutment in the middle of the river with rocks around it.The boat was going in circles down stream until it hit a shallow spot around a island about 50 yards down stream and the prop blades broke off and it was caught in a eddie at the bottom of the island.I was laying on the rocks with blood on me and the side of my rain suit shredded in shock.It was a hour before dark and I knew nobody would be by.I could not swim to shore because of the really strong current on each side.There was a big eddie from the abutment to the island and as I was shivering I decided to swim to the island to get the boat circleing in the eddie.In 38 degree water I swam down got to the boat and hopped in it.The motor was still running but there was no blades on it,so I paddled 3 miles down river to the boat landing where a guy fishing from shore helped me.The shock had worn of some by then and I found most of the blood was from a big cut on my thumb and the suit I was wearing saved me except for some miner cuts the prop caused.The boat motor had hit me so hard my whole right side was a deep purple for 2 weeks and if the motor had not been turned to the right I would have looked like the guy in the above picture.I always wear a life perserver now and have the kill switch hooked up.The good lord was with me this day and I know how lucky I was.Do not let this happen to you.

    redrnger
    Posts: 216
    #1403746

    One problem might be that it wont tilt up far enough and you get e rooster tail from it draging in the water on plane other wise the extra 5 wont bother the fish.

    redrnger
    Posts: 216
    #1403592

    I have always found them in eddies or the seams of rivers currents and you can catch them using about everything in the smaller sizes.Rooster tails,small jigs-minnows-rapalas-three ways pulling flies.Experiment with different baits but if there in the area you will useually catch them on 1 of them.

    redrnger
    Posts: 216
    #1403581

    I have been there and done that and after it is done you will feel better in no time.Keep a positive attitude and do as told and you will be fine.Put you in our prayers.

    redrnger
    Posts: 216
    #1403213

    I look at craigslist all the time and the used boat ads on other sites. I love buying boats and fixing them up the way I would want them done.I fish from them awhile then sell and find anouther project boat.Maybe we should start a boat addiction group.Looks like theres enough people on here.

    redrnger
    Posts: 216
    #1403208

    Called them and they said they always fill them half way with usb seals but that they would send there tech over and fill them all the way to give me peace of mind as I told them thats what Ranger recommends.

    redrnger
    Posts: 216
    #1402485

    The wrong people can get your address by running your plate number.Wake up car be gone.

Viewing 30 posts - 1 through 30 (of 190 total)