Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Glynn Plantz
    Posts: 9
    #1666626

    My sensitivity goes from 62-82% any given waters. Depends on clarity for the most part. Colorline I think is around 64? Setting is fresh water, manual settings, manual depth. Elite 4 may differ, so use your own judgement.

    First couple times using mine didn’t figure stuff out thoroughly and had very frustrating times. It’s tough to put down the rod but do it, well worth it.

    Why freshwater over ice mode?

    Glynn Plantz
    Posts: 9
    #1666623

    Have any of you used the amplitude scope?

    Glynn Plantz
    Posts: 9
    #1666616

    2d Split Zoom is awesome but I also like doing dual frequency. I can set up a jigging rod in the small cone and a dead stick in the other and watch them both from the same hole. Learning to use my Elite-5 to its full potential I think I’d get bored with a regular flasher.

    Any recommendations for settings?

    Glynn Plantz
    Posts: 9
    #1666580

    You have in auto range mode? My elite 5 doesn’t seem to like to work in auto, adjust depths accordingly. Guess I really don’t use the flasher mode either. Switch to the 2d with split zoom feature, awesomeness. Believe Kieth kav. And Gary Parsons are fans of this way as well. Alot easier reading bottom composition as well.

    What setting do you use other then split zoom?

    Glynn Plantz
    Posts: 9
    #1666274

    First off, love the show! Second I think you should do a show on Bay of Quinte for Walleyes!

    Glynn Plantz
    Posts: 9
    #1665885

    Thank you for your time. I have started to use split zoom now. I always had it in ice mode, but also in auto so I will try manual next time out. The picture is from yesterday.

    Attachments:
    1. IMG_20170115_112341_698.jpg

    Glynn Plantz
    Posts: 9
    #1665691

    It seems to show lots of white space and loses my lure.

    Glynn Plantz
    Posts: 9
    #1654905

    What about a Bullwhip with a inline reel? What line would you recommend?

Viewing 8 posts - 1 through 8 (of 8 total)