MTRanger, I was thinking the same thing. I’ll be looking at mine this weekend in preparation for doing that exact same setup.
After taking a closer look at the picture provided by Cal. I notice the new consoles have an angled section, and My 2016 WX 2060 is pretty much straight. I think I will have to get some HDPE or something similar so I can built an angled bushing to go behind the flange on the rod tube thing.
Do you think it would be possible to retro-fit those rod cubbies to a previous model WX.
I have a WX 2060, I and tow mine with Skeeter cover on. I also have a Rock Tamer to help know down rocks kicked up by my tow vehicle.
My boat came with a my-wedge and that is all I used, I believe it came from the factory and not the dealer.
My 2016 WX 2060 after the maiden voyage.
20160409_183857.jpg
I have tried some 303 based on some of the reviews I read. I used it a couple of times and I didn’t like as well as some of the other products I have used. I have a mostly full bottle that I will probably never use.
Out of curiosity how well does it work as a beverage cooler.
When is the pricing for these boats going to come out and what’s all exactly included?
http://WWW.skeeterboats.com/wx2060
http://www.skeeterboats.com/mx2040
I know a lot of people probably don’t like the no substitutions thing and not being able to customize your colors.
However I wasn’t even considering getting a WX 2060 until I heard about this deal. I am stoked and I will be placing an order sometime this fall.
Some nice subtle changes to the MX!
FDR
That is for sure. Those subtle changes took care of all the grips I had on the 2015 models. I will be ordering a 2016 WX in the near future.
That is the vent for the fuel system
Thanks
