Thanks for the replys guys. I ended up using a method similar to what djshannon discribed except a little more extreme. My point was pretty banged up (think boat motor prop that has hit a rocky bottom), so I wasn’t able to keep the factory edge and had to grind a fair amount off. I havnt had a chance to test it out yet though. Worst come to worst I’ll end up buying a new bit.

djshannon wrote:

Phil, where are you? I am in Crosslake if you are any where close. I will get you started.

I am in east central SD but thanks for the offer!

dairycat wrote:

Just need a new power point. $13 at drock

I wish it was as easy as that. The point is welded to the shaft on this style of auger.