Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • jobobranger
    Posts: 10
    February 25, 2014 at 4:52 pm #1391628

    Thanks Glenn. I called Ranger and they confirmed this. Sorry I forgot to post it. Jim

    jobobranger
    Posts: 10
    July 14, 2013 at 8:49 pm #1183282

    I put some clear caulk around mine and it holds fine. Jim

    jobobranger
    Posts: 10
    July 9, 2013 at 12:21 am #1182264

    I ended up mounting it on the lower right side by the drain plus area. I am reading depth at 55 mph and the downscan screen keeps up with the bottom change. Very happy with the Elite so far. Thanks for the input John. Jim

    jobobranger
    Posts: 10
    July 3, 2013 at 1:48 am #1181467

    I am going to mount on transom. Again lowrance said it would read better here than in the hull. Jim

    jobobranger
    Posts: 10
    July 1, 2013 at 2:00 am #1181110

    Eyechasaer, any chance you can send a picture? Used the Elite todaynandnloved it. May add a second one to the dash. Jim

    jobobranger
    Posts: 10
    June 29, 2013 at 3:15 am #1180930

    Thanks guys. Mine is just the downscan only. Similar to normal skimmer type, only bigger. 3 in long by 2 in wide. Spoke with Lowrance and they recommend on transom for best sensitivity. That is the way I am going to go. Thanks again, Jim

    jobobranger
    Posts: 10
    April 1, 2009 at 12:27 am #764456

    I have a 619 and would not be able to fish alone without these steps. I am also recoverying from hip surgery and they help alot. I don’t think they are pricey as they are well made and built to fit your particular trailer. I didn’t want to save a few bucks to fall on my butt. Mark makes a great product. Give him a call if you have any questions. Mine are 2 years old and still look like new. Jim

Viewing 8 posts - 1 through 8 (of 8 total)