This day and age you can’t expect much for $99. And I don’t .. I’m just hoping for it work a little bit better then it does… When I get all the “Operator” errors out of the way.. we will see. I read a lot of reviews and 90% are pretty positive..

Yeah .. I figured that.. I did see blobs ,, but the arches ..like I said where so prevalent on the “demo ” mode ..I figured just a couple of tweeks and would see them too. Only using a 30 Lbs trust trolling motor I wouldn’t think speed would be causing that big of a deal..

LOl …thats true on the manuals .. Where at in Iowa ? I’m from Wilton.. I’ll give it a try and see if that defines it better ..I believe I have the transducer set right.. its mounted about a foot away from the motor. The bracket is as low as I can get it and the transducer is hanging about an inch lower then the boat.. and the line is about as straight as I can get it. Yeah it took me a good half hour of searching to figure out how to get the quick release mech to work. not even in the manual..

Ps.. I’m running it in 200hz mode and sensitivity is about 75% .ping rate is fastest.