If you guys have the 115, aren’t you able to use VessleView for your fuel readings? I guess you’d have to reset it each time you fill up, but it should be a much more accurate gauge of your fuel burn.

Negative, laundry room is on the backside of that wall. This isn’t our forever house so I’m not undertaking anything like that. Trying to sell her on a Tahoe instead of the smaller Volvo XC90, as the Tahoe won’t fit in the garage and our problem is solved

Thanks for the quick replies, guys. Looks like I may be stuck with the 16 footer unless I can convince the wife to park in the driveway and put the boat in at an angle.

Another question regarding the storage compartments in the bow: are there gaskets around the edges to keep water out? Doesn’t look like it from the pictures. I’m sure something can be rigged up if not

Hey guys, looking pretty hard at the Adventure 1775 but need to make sure it’ll fit in the garage. Would one of you owners with the 115 do me a solid and provide the following measurements?

-Do these trailers have a swing tongue? If so, what is the length from tip of prop (motor down) to forward-most point of package? I can’t tell from pictures but it looks like the bow point protrudes past where a swing coupler might be.

-If no swing tongue, what is the length from the tip of the prop to the point on the trailer just in front of the bow stop post?

-width of trailer fender to fender

-Height to the top of the windshield (walk-thru model) while on the trailer

I have about 18.5 ft. if I back straight in and hoping I can manipulate the trailer to make that work. I really appreciate the help!

I totalscan combines chirp/downscan/sidescan all in one transducer. I tried going into the menus but no luck. I’m also sitting on a concrete pad so I’ll try to get out this weekend and see if being on the water makes a difference.

I have the totalscan transducer and don’t see the option to switch to pure downscan. Any screenshots by chance?

I downloaded to a microSD and my Elite 7-TI seemed to perform the update, as there is now an auto-pilot function on my screen. However, when I go into Sonar, I don’t see the FishReveal tab that the videos show, nor do I see any new options under the sonar type. Is there something I need to do to activate that? Using with a Navionics chart card if that makes a difference.