just made one out of a coleman swell tip man thanks. i went one step further though and got a bubbler. i used a neopreme coozie for ins on the bubbler it fit perfect. than i taped it to the side with some duct tape. and here is where i went wrong. than i cut the spout off and siliconed it in the open position and iserted the hose and siliconed itin place for a water tight seal. so now every time i take the lid off i twist the hose up. my answer for this though is to drill a 3/i6 hole just below where the lid screws on and than silicone the hose in and not worry about the spout. used it for the fist time sun and it worked great. it did however form some ice in it but was way better than a unisulated bucket and it was only 5.00 bubbler was ten great tip though thanks