Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Elwood anderson
    Posts: 8
    September 3, 2020 at 8:01 pm #1970461

    Ok y’all SUCCESS. CHECKED CONTINUITY from neutral switch to next point. It was a broken wire at the connection. Replaced and fired right up . Thanks everyone for helping.one note the wire was rubbing on the control box shifter too.

    Elwood anderson
    Posts: 8
    September 3, 2020 at 8:49 am #1970252

    It’s a 92 evinrude and yes. Usually crank about twice a month with no problem. One day it started this. Btw I replaced what looked like a frayed wire to safety and one of the wires was off. After fixing and re attach still no response. Tried to jump wires but still didn’t turn over

    Elwood anderson
    Posts: 8
    September 2, 2020 at 7:17 pm #1970121

    So I found a loose wire on safety switch. Plugged in no response. Also what looked like a wire that had rubb thru,fixed that . Bypassed the switch to try by using a jumper ,still did not turn over

    Elwood anderson
    Posts: 8
    September 1, 2020 at 5:28 pm #1969811

    Is that in the control box,maybe some wires going into it

Viewing 6 posts - 1 through 6 (of 6 total)