I used the standard Cisco Sure-Lok and the Ram-109-HU swing arm. I have the high speed transducer on the hull and the Down and side imaging transducers on a board.I have an Helix 10 upfront and linked to the Helix12, 360 and ILink Ulterra. the Onix is a stand alone unit. Skeeter Boat Center set it all up, so give them the credit. Eric and his team always do quality work!!!
IMG_0021.jpg
Here is a Helix 12 and onix 10 on a WX 1910, Cisco and Ram Swing Mount.
IMG_0020.jpg
I had the same issue a few years back, thought I needed an alignment. went the a trailer shop and he said you can’t do an alignment on my trailer. He jacked it up and spun the tire. It wobbled as suspected. Long story short, I had a bearings going out, I was lucky it didn’t happen on a trip. Drove a lot of mile on it that way.
Ran a 19P this weekend, 5900 RPM 56 MPH, good conditions. 3 people in boat, 20 gallons of gas.
18P Reliance, hole shot is great, and will use as a ski prop. Going to test a couple others in the next week or so. Will get a better judge of performance this weekend as I am the coach/boat driver for my sons high school bass fishing team and we will be in the state tourney on lake carlyle in Illinois. Wind is supposed to be mid to upper teens on a good sized lake. The boat will get a nice “test” this weekend.
I have had mine out a couple of times and love the boat!!! After breaking it in I am hitting 54 MPH very easy but going over 6000 RPM’s so I need to continue to test a few props to get the best fit. I think Dean is on with his 56-57 MPH. I am running my in Illinois. Love the tall windshield and the boat tracks awesome. It turns on a dime with no prop slippage at all. I have been really impressed so far.
