Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • cuh7111
    Posts: 2
    #819154

    Unfortantly I have not made it to the water yet…To busy Deer Hunting . But hope to be on the lake next week-end. Wire not a problem. hooked the hot and ground on the block under the console, and wired all yellows togeather (this turns on the LSS-1 when you press power on the HDS)With regard to pictures here u go. Two of the tansducer mount and several of the box under the console.

    http://s771.photobucket.com/albums/xx352/cuh7111/LSS-1/?albumview=grid

    cuh7111
    Posts: 2
    #817634

    Yup Received my Side Scanner on the 19th. I preordered on 9/11/09. Just got it installed in my Ranger Z520. Did manage to get the control box mounted under the Dash after fabricating an Aluminum backer plate (3/8 inch). I threaded the backer plate to match the holds on the module and then anchored the backer plate under the console and then mounted the module to it (out of sight and high and dry). While at the machine shop I had them fab’ed an aluminum transducer mounting bracket. I threaded the piece to match the mounting screws pattern on the transducer mount and secured the transducer bracket to the aluminum mount. I then drilled the aluminum bracket to match existing bolt holes in the jack plate. Now if it will only stop raining so I can try it out.

Viewing 2 posts - 1 through 2 (of 2 total)