Forum Replies Created

Viewing 9 posts - 1 through 9 (of 9 total)
  • buku
    Posts: 10
    January 1, 2023 at 5:00 pm #2170632

    I ordered these from Amazon for Okuma Ceymars and so far there are working out.
    A

    Attachments:

    1. 25BA9FD8-31F9-464D-BDCE-BFC804BCFD98.jpeg

    buku
    Posts: 10
    December 16, 2020 at 2:46 pm #1997891

    Thanks James! This gives me a good start and hopefully I can report back with some success stories. I have my settings way too high which drowns everything out. Appreciate all the info!

    buku
    Posts: 10
    December 15, 2020 at 6:24 pm #1997637

    That’s awesome. I’m still trying to get my set up dialed in, only been out once. Would you be willing to share the settings so when I’m on the ice, I can just fish? A picture of the enhanced setting would be helpful. Thanks!

    buku
    Posts: 10
    November 28, 2020 at 11:10 am #1992088

    Thanks for posting this James. I set mine up last night with plans to take it to Red on Thursday. I have been searching the internet for more info, but have not found anything useful. Does the helix go into Ice or Open Water mode? It does not give me an option for the 360 transducer in Ice mode. If you wouldn’t mind posting an update when you use it, that would be great. Thanks in advance!

    buku
    Posts: 10
    July 14, 2020 at 9:26 pm #1957295

    I just pulled off a HDSI ducer from my Gen1 Helix 9.

    Attachments:

    1. 9A195876-BC00-4F16-A205-28CA83987B7C.jpeg

    2. A8860DBD-6E45-4546-B8F5-889D66215873.jpeg

    buku
    Posts: 10
    October 11, 2018 at 2:58 pm #1803085
    Tuma wrote:

    That looks nice buku. You might want to put some black elc tape on the top of the LED lights so it doesn’t blind you. If you don’t like it you can always take it off. toast

    Thanks Tuma, thats a great idea!

    buku
    Posts: 10
    October 11, 2018 at 2:57 pm #1803082

    Its the 9, but looking to add a 5 or 7. Just wanted to make sure everything works so I pulled the 9 off of the boat.

    buku
    Posts: 10
    October 10, 2018 at 11:42 pm #1802932

    Just finished this tonight…

    Attachments:

    1. Helix-setup.jpg

    buku
    Posts: 10
    January 6, 2018 at 3:38 pm #1741843

    I had the same thing happen to me after a few uses. I took it apart and moved the thermalcouple (the sensor in front of the pilot light) up a little so it was closer the flame. I didn’t think it was heating the sensor enough. Works like a charm now. Hope this helps

Viewing 9 posts - 1 through 9 (of 9 total)