Forum Replies Created

Viewing 10 posts - 1 through 10 (of 10 total)
  • Raymond Blimkie
    Posts: 12
    #1566998

    Hi, pretty cool, I either jig for walleye or troll. This would be awesome for seeing what jigs are attracting or not. Question, I troll rapalas off a cannon ball, but typically back 20-30 feet for walleye, would the panoptix work, can I dial in lure that far back?
    Raymond

    Raymond Blimkie
    Posts: 12
    #1544051

    Hi guys I plan to add a second Humminbird with SI later, budget is maxed right now. Joe MX1835 I like you location, but like Pale Ryders bracket, thinking thats the way to. Thanks for feed back.
    Raymond B

    Raymond Blimkie
    Posts: 12
    #1543867

    Worked good cheaper than buying a piece of aluminum. Note I ran clear vinyl tape on the edges of the level so I would not scratch the boat.

    Raymond Blimkie
    Posts: 12
    #1543775

    Test transducer results.
    Raymond B.

    Attachments:
    1. 28-In.jpg

    2. Final.jpg

    Raymond Blimkie
    Posts: 12
    #1538059

    Hello pale ryder, I had looked under the dash and could not find any accessory wires. I started to run a fused wire from the battery up to the front then was thinking about your post. I decided to look again. I snipped about 8 cable ties and found all the accessory wires were there, they had been hidden away inside a bundle of wires. I tied into accessory 1, and good to go. I was out checking my transducer set up yesterday and had no issues. If I ever do have power problems I have a wire run now directly for the battery. Thanks for your post.

    Raymond Blimkie
    Posts: 12
    #1537601

    Thanks for the feedback guys, I will be working in the garage tonight hooking things up.

    Raymond Blimkie
    Posts: 12
    #1537475

    Yes, that’s simpler, and I just saw a video where they were talking about making sure you have good clean power to your unit. Thanks. a
    ny other input out there.

    Raymond Blimkie
    Posts: 12
    #1536164

    My first Skeeter MX1825. To be cruising for Walleyes in the St Lawrence and Ottawa rivers.

    Attachments:
    1. IMG_20150418_135443.jpg

    Raymond Blimkie
    Posts: 12
    #1529809

    Thanks Calvin for the info. I have seen allot of different transducer locations now on the mx1825. Thinking I’m going to make a backer plate up and clamp from the top of the transom so it closest to where I think is the best location then test. will send photos when complete.

Viewing 10 posts - 1 through 10 (of 10 total)