I just recently updated thesoftware on the three graphs in have on my boat (HDS 9 Carbon, HDS 9 Gen3, HDS 7 Gen2). All of these units are linked via Ethernet cable. I recently just got navionics plus and once I put the card into my boat all three graphs synced right to navionics. But as I did some more playing around I started to set some waypoints just to make sure everything was linked and ready to go. When I went to set a waypoint on my Carbon unit, the waypoint wouldn’t even appear. I would hit save and everything and it never showed up. I have all my settings set right that my waypoints should appear, but for some reason they don’t. When I set a waypoint on my HDS 7, it appears but does not send it over to the Carbon. Before I updated the units and before I had to navionics plus chip, all the waypoints showed up on all 3 units and everything was smooth running. Wondering if any of you guys have ran into this problem and have some advice.
DE
