Alma ramps

  • crawdaddy
    St. Paul MN
    Posts: 1604
    September 27, 2013 at 4:32 am #1334341

    Is there a fee in effect now for launching at the alma marina and also the power plant? If so do you know the cost for someone from MN?

    bigpike
    Posts: 6259
    September 27, 2013 at 4:49 am #1197105

    $5 bucks a day for non resident of the city of Alma at the marina. I would guess the one below the dam in town is the same. Next ramp south at Belvidere Slough should be free from the grips of the city of Alma….

    drew-evans
    rochester MN
    Posts: 1099
    September 27, 2013 at 9:44 am #1197110

    Belvedere is free

    ironheadr5
    Northeast, Iowa
    Posts: 373
    September 27, 2013 at 3:56 pm #1197181

    Are you talking about the one by the Power Plant? ??

    bigpike
    Posts: 6259
    September 27, 2013 at 11:17 pm #1197287

    Take 35 south of Alma and hit County rd. Oo, this takes you into Buffalo City. Landing is on the right hand side a few miles in. Can’t miss it. Otherwise keep going and hit the one in “downtown” Buffalo.

    Brian Klawitter
    Keymaster
    Minnesota/Wisconsin Mississippi River
    Posts: 59992
    September 28, 2013 at 2:39 am #1197316

    Quote:

    Take 35 south of Alma and hit County rd. Oo, this takes you into Buffalo City. Landing is on the right hand side a few miles in. Can’t miss it.

    fireline
    Rochester
    Posts: 813
    September 28, 2013 at 7:51 pm #1197386

    where does the Belvedere landing come out onto the main river ?

    bigpike
    Posts: 6259
    September 28, 2013 at 7:59 pm #1197388

    If you follow the channel due north and take the cut to the left it will bring you out at mile marker 748, maybe 3/4 miles from the landing

    Tom P.
    Whitehall Wi.
    Posts: 3526
    September 30, 2013 at 12:05 am #1197491

    Be careful and pic the right opening there is a shallow closing dam across one of them. Normally you will see markers to go between to get over the dam.

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.