The power went low/out on my Ulterra while on the river. After a little scramble getting the big motor down and back under control in the fast current,.. I set an anchor in a current seam. Then we realized that this isn’t just a speed bump because we can’t stow it without power. I tried the remote and it lit up and then went blank again. I hit the on/off switch on the motor with no response. How would we get back up the fast current and how would we get back on the trailer. After some messing around I got it fired up and it partially stowed and then finally stowed. In retrospect,…I suppose I could have slid the whole thing off the sliding mount. At home,..Batteries checked out strong, a little corrosion but not bad on the terminals, screws tightened a tiny bit on the male plug and a little again on the female plug terminals. There is a big Buss 60 amp fuse with a yellow arm that was out. The motor lights up now but am wondering if the fuse should be replaced?? Not sure what else can go wrong unless the wires from the last battery to the front of the boat somehow got frayed. Thoughts?? Thanks
Ulterra issue yesterday
Viewing 8 posts - 1 through 8 (of 8 total)
You must be logged in to reply to this topic.