Trouble attaching my clam mate to my new k drill????????????????

  • Travis Fuller
    Posts: 7
    December 4, 2018 at 2:21 pm #1815032

    having trouble attaching my clam mate to my new drill. I have slid down the foam floating piece and put on the new attachment I ordered from clam. Anyone else have this issue.

    CBMN
    North Metro
    Posts: 974
    December 4, 2018 at 2:31 pm #1815040

    I guess I did the same thing last year and didn’t have any issues. I guess a photo and or a better explanation of what is not working would be helpful.

    fishthumper
    Sartell, MN.
    Posts: 12157
    December 4, 2018 at 4:12 pm #1815067

    There is a adapter that is needed – You then need to remove the insert on the K-drill shaft – If you are talking about attaching the Clam Plate to a K-drill. Otherwise I’m not sure what a Clam Mate is?

    Travis Fuller
    Posts: 7
    December 6, 2018 at 8:04 am #1815437

    that attachment only works on the new clam plates not the old.

    Travis Fuller
    Posts: 7
    December 6, 2018 at 9:45 pm #1815267

    I have spoken with clam customer service and my clam plate is outdated.. the k drill will not work unless the conversion kit I ordered is cut to fit the old clam plate etc………..so looks like I either order the newer version or just use a drill

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.