Troll Master and T-8 Yamaha

  • igotone
    Posts: 1746
    December 2, 2017 at 5:22 am #1732117

    I’m looking at installing a Troll Master on my T-8 tiller.

    Can IDO members post me some pictures on where you ran the servo power cable into your motor?

    thanks in advance for your time and pictures

    SuperDave1959
    Harrisville, UT
    Posts: 2816
    December 5, 2017 at 8:11 pm #1733141

    Rubber boot on the port side of the motor.

    igotone
    Posts: 1746
    December 10, 2017 at 8:05 am #1734324

    thanks superdave
    anybody else got ideas
    looks like you have to cut a hole for it on yours

    mark-bruzek
    Two Harbors, MN
    Posts: 3875
    December 10, 2017 at 10:44 am #1734349

    Make sure none of your servo wires run near any spark plug wires or ignition coil/CDI box.
    Figured this out the hard way after a buddy did his own install and it was very erratic, changing its own speed randomly. The servo wires were picking up stray high voltage current via induction.

    igotone
    Posts: 1746
    December 11, 2017 at 4:17 pm #1734696

    Thanks Mark, for the heads-up.

    I do plan on doing the install myself so any help is much appreciated.
    that’s also why I wanted to see some pictures of where to go into the motor.

    thanks again for any and all help, IDO members !!!

    marineman
    Posts: 105
    December 20, 2017 at 12:37 pm #1737043

    I had enough space on mine to run it in with one of the other cables; I believe it was the lower RH side in the picture superdave posted.

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.