Svu/Dvu tranducer

  • fishbait
    Posts: 149
    May 24, 2019 at 6:16 am #1858585

    I am planning on putting a tranducer on my Terrova trolling motor and running the wire
    through the groove on the shaft. Good or bad? Appreciate any feed back. Thanks

    Huntindave
    Shell Rock Iowa
    Posts: 3092
    May 24, 2019 at 9:06 am #1858607

    I’d check with both MinnKota and the manufacture of your sonar unit, to see what they say about this. I would assume this will require quite a bit of disassembly to get the wire (with connector) run up thru the groove.

    to_setter
    Stone Lake, WI
    Posts: 593
    May 24, 2019 at 9:27 am #1858622

    I had one rigged up this way. Just used silicon to “glue” the transducer cord into the groove on the shaft. I used it that way for 4 years without any issues at all.

    Charles
    Posts: 1979
    May 24, 2019 at 10:53 am #1858641

    lowrance or Humminbird?

    Humminbird uses a smaller cable compare to the Lowrance

    to_setter
    Stone Lake, WI
    Posts: 593
    May 24, 2019 at 11:10 am #1858644

    The one I had was Humminbird.

    tpmorgz
    Central Iowa
    Posts: 257
    May 24, 2019 at 2:35 pm #1858698

    I did it many years ago and have had no issues. Used marine silicone adhesive. There is a youtube video out there somewhere that shows how.

    tpmorgz
    Central Iowa
    Posts: 257
    May 24, 2019 at 2:38 pm #1858700

    This is the link to the one I believed I watched.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.