Skeeter Boats Newest Model – Sneek Peak @ WX2060

New windshield!

Between the wx2060 and the new wx19?? Where would the difference in length be applied?
Is it just in the bow?
If so, I would wait and would be happy with the 19?? because I prefer the size of the cockpit on the new 2060.
Where do they usually apply the additional length between boats of these two sizes? Bow or overall?

Too early to call as no spec’s have been released yet

What is the benefit of the new windshield? Can you put them on the ’13s

Can we get some more pictures of the inside please,

Quote:

---

What is the benefit of the new windshield? Can you put them on the ’13s

---

Slightly taller more dash room for electronics. The 2060 is the only boat today for the windshield. No doubt more models will have them but unable to say when & which models at this time.

Quote:

---

Can we get some more pictures of the inside please,

---

A few more !

Quote:

---

Quote:

---

What is the benefit of the new windshield? Can you put them on the ’13s

---

Slightly taller more dash room for electronics. The 2060 is the only boat today for the windshield. No doubt more models will have them but unable to say when & which models at this time.

---

I have seen the 2014 2190’s with the new windshield, so i didnt know if they could be put on the 2013 2190’s.

I would believe they would…..but hole patterns will more than likely not match. We have not rigged a 14 2190 yet.

Dean or anyone else, what are we looking at for an approximate price for the wx2060 with the offshore 250, T9.9 kicker, 80lb Terrova, etc.
$50,000?

Any updates on the 2014 wx19??

I would rather have the cooler step. Those boxes are way too small. Waste if you ask me.

Quote:

---

Dean or anyone else, what are we looking at for an approximate price for the wx2060 with the offshore 250, T9.9 kicker, 80lb Terrova, etc.
$50,000?

Any updates on the 2014 wx19??

---

No updates expected for a few months.

Mid to upper 50s dependent on options. Lots of potential variables.

Quote:

---

I would rather have the cooler step. Those boxes are way too small. Waste if you ask me.

---

Appreciate the opinion & not everyone is the same…I use a lot of 3600 boxes myself. But to each their own ! :]

Yamaha has the performance bulletin on their website for the WX2060 with F250

Link to PDF: http://www.yamahaoutboards.com/sites/default/files/bulletins/SKT_WX2060_F250XCA_2013-11-18_WLY.pdf

Wow, that’s a lot slower than what I was hoping for.
I wonder if the new wx19?? with the F200 and T9.9 will be any quicker?

Quote:

---

Wow, that’s a lot slower than what I was hoping for.
I wonder if the new wx19?? with the F200 and T9.9 will be any quicker?

---

Maybe not, the current WX1900 with the F200″B” is only at 50 and change.

http://www.yamahaoutboards.com/sites/default/files/bulletins/SKT_WX1900_F200XB_2013-08-06_WLY.pdf

HRG

Just remember that boat was tested at a way different elevation and with a saltwater prop and REAL world conditions and load.
I am going to speculate and say that boat will probably do 55 around this area. I could be wrong though.
The biggest thing to remember though is that boat is “loaded” and got those results. Trolling motor, batteries, 51 gals of fuel, 2 people, 100lbs of gear, etc.
I believe that is a pretty safe baseline to go off of!

So you think the 250 with the turbo 21p prop would be a better fit and would get a little more out of it?

I really don’t see why the 300 isn’t an option for the wx2060. If I’m going to spend 60k on a boat it better do 60mph. Just sayin’!

Quote:

---

So you think the 250 with the turbo 21p prop would be a better fit and would get a little more out of it?

I really don’t see why the 300 isn’t an option for the wx2060. If I’m going to spend 60k on a boat it better do 60mph. Just sayin’!

---

That motor will not swing a 21p on that boat. You would lose speed if you did that.
The 300 isnt an option because they rated it for a max 250, is the only answer I have.

Quote:

---

So you think the 250 with the turbo 21p prop would be a better fit and would get a little more out of it?

I really don’t see why the 300 isn’t an option for the wx2060. If I’m going to spend 60k on a boat it better do 60mph. Just sayin’!

---

Buy a bass boat.

I ran a Ranger for 10 years and never, never in that time had a fish jump in the boat at anything over 3mph.

Speed is over rated.

If I can get nearly the same mph and better mpg with the new wx19?? w/F200xb&T9.9 and save approximately 10 grand, I would say it’s worth the wait.

I must admit that my 300 on my 2025 was fun!

What is the overall length of the wx2060 with the 250 yammy hangin’?

Quote:

---

What is the overall length of the wx2060 with the 250 yammy hangin’?

---

Anyone? I need to know if I can fit this puppy in my garage. Total overall length from tip of trailer tongue to the farthest point of the yammy 250?

Quote:

---

Quote:

---

What is the overall length of the wx2060 with the 250 yammy hangin’?

---

Anyone? I need to know if I can fit this puppy in my garage. Total overall length from tip of trailer tongue to the farthest point of the yammy 250?

---

Did you order the boat offline? I would say if you are seriously thinking about buying it. Go take a look at the boat and bring a tape measure with. The boat is brand new. There are only a couple people that have seen this boat in real life. Not sure there are many people that can give you this answer.

Quote:

---

Quote:

---

What is the overall length of the wx2060 with the 250 yammy hangin’?

---

Anyone? I need to know if I can fit this puppy in my garage. Total overall length from tip of trailer tongue to the farthest point of the yammy 250?

---

Its going to take 25′-9″ + from the rear wall to the struts on your overhead door to fit this baby in. A smidge over 24′ if you swing the tongue.. With the new windshield, Im pretty sure it will go under an 84″ high opening, but its gonna be squeaky tight.

Quote:

---

Quote:

---

Quote:

---

What is the overall length of the wx2060 with the 250 yammy hangin’?

---

Anyone? I need to know if I can fit this puppy in my garage. Total overall length from tip of trailer tongue to the farthest point of the yammy 250?

---

Its going to take 25′-9″ + from the rear wall to the struts on your overhead door to fit this baby in. A smidge over 24′ if you swing the tongue.. With the new windshield, Im pretty sure it will go under an 84″ high opening, but its gonna be squeaky tight.

---

Thanks! That sure is a beauty!

Quote:

---

Quote:

---

Quote:

---

Quote:

---

What is the overall length of the wx2060 with the 250 yammy hangin’?

---

Anyone? I need to know if I can fit this puppy in my garage. Total overall length from tip of trailer tongue to the farthest point of the yammy 250?

---

Its going to take 25′-9″ + from the rear wall to the struts on your overhead door to fit this baby in. A smidge over 24′ if you swing the tongue.. With the new windshield, Im pretty sure it will go under an 84″ high opening, but its gonna be squeaky tight.

---

Thanks! That sure is a beauty!

---

What about the widest point? Is it the trailer width or is the boat wider when on trailer?

Quote:

---

What about the widest point? Is it the trailer width or is the boat wider when on trailer?

---

The Skeeter site shows 102″ overall width, with a 98.5″ beam, so the trailer width is the widest.

http://www.skeeterboats.com/products/11/41

HRG

Quote:

---

Quote:

---

What is the overall length of the wx2060 with the 250 yammy hangin’?

---

Anyone? I need to know if I can fit this puppy in my garage. Total overall length from tip of trailer tongue to the farthest point of the yammy 250?

---

With the motor in the trailerable position and the tounge folded in, it measures 23′ 6″ and that gives you a couple inches to spare.
Widest point would be the trailer and they are usually 101″ or 102″.