2004 Ranger Trailer Jack

  • walinutz
    Cologne, MN
    Posts: 370
    March 12, 2014 at 11:35 am #1360574

    thinking of going to a Fulton F2 Trailer track. has anyone used these? is it easy to mount with the C-channel framing on the trailer?

    mojogunter
    Posts: 3317
    March 12, 2014 at 11:49 am #1395630

    They are easy to mount. Doesn’t you Ranger trailer have the jack in the middle of the frame that was made special for Ranger? When my Jack went bad I looked for a replacement but was told I had to go through Ranger to get one. Ranger did replace it though under warrantee.

    jon_jordan
    St. Paul, Mn
    Posts: 10908
    March 12, 2014 at 12:02 pm #1395633

    You can bolt on any jack you want. (C-clamp bolts that come with the jack) But you have to order the one for your trailer through a dealer. Bolt patterns are specific to Ranger. OTC will not fit.

    -J.

    walinutz
    Cologne, MN
    Posts: 370
    March 12, 2014 at 3:05 pm #1395656

    I do not have the center mounted jack. It is bolted directly to the trailer on the side.

    so, what I understand if I want to mount a jack in my old jack holes I will need to go to a dealer? If I use the C-bolts I can mount it anywhere?

    jon_jordan
    St. Paul, Mn
    Posts: 10908
    March 12, 2014 at 3:13 pm #1395658

    Quote:

    so, what I understand if I want to mount a jack in my old jack holes I will need to go to a dealer? If I use the C-bolts I can mount it anywhere?

    Exactly.

    -J.

    redrnger
    Posts: 216
    March 12, 2014 at 7:26 pm #1395709

    Mine was attached on the frame to.I bought a Fulton and if I remember right 2 of the 4 holes line up.I drilled out 2 of the holes and rebolted it. It has been 6 years and works fine and you can put a heavier duty 1 on.If it goes bad again you can just change it out and do not need the Ranger only 1.Had my boat 14 years still going strong.

    walinutz
    Cologne, MN
    Posts: 370
    March 24, 2014 at 11:51 am #1398841

    did you drill out the trailer holes or Jack stand holes?

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.