I recently purchased an Eskimo stingray s33 8″auger. It has drilled about twenty or more holes no problem. We had some others use it to pop a few holes and while trying to get it started it got flooded (this happened a couple of times). We were able to get it started again and it now starts just fine, one or two pulls. The issue now is we can not get it to open up. It starts and idles just fine, but when you hit the throttle it will start spinning but then bog down and stop. The engine continues to run but it can not drill a hole. Super disappointed with it, especially that it is new. Any idea of what the issue might be would be greatly appreciated.
question about eskimo stingray s33
Viewing 2 posts - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.