Powerdrive Trolling Motor Help

I have an 80 lb 24v powerdrive tm with pedal and remote. I used it Tuesday and it worked fine, I recharged the batteries and used it again yesterday
After about 5 minutes it started beeping and then quit working. I tried it again later and same thing. Then I tried it again and nothing at all. I disconnected the pedal and tried the remote and vice versa. Connections are good couldn’t steam to track down a inline fuse. Any suggestions?

Possibly catastrophic battery failure or charger failure. What’s your battery voltage read on a meter? (Not the lights on the motor).

I haven’t had a chance to get to it. I just looked it over while fishing and trolled with the big motor and enjoyed the rest of time just being on the water

Check your on board charger fuses

Thanks guys. Found out there’s a reset button on the fuse and that was it. Do they get weak ? I’m gonna replace it anyways

Fuses don’t have reset buttons, they just burn out. A circuit breaker has a reset button like this one from MinnKota:
https://minnkotamotors.johnsonoutdoors.com/accessories/trolling-motor/circuit-breaker-mkr-19
A circuit breaker will trip for a reason. You may have a wiring issue. Clean all your wire terminals and connections whether they look clean or not.

Thanks Ron bad wording on my part, my breaker is a little different then the one that shown on your post. The connections to my breaker are a little rusty so I cleaned them and went through the battery connections and anything else I could find. Im going to replace the breaker. I was going to post some pictures but I’m not having any luck