Otter xt 1200 resort

  • benelli-bob
    Eagan, MN
    Posts: 311
    February 14, 2015 at 2:36 pm #1511588

    Can any of you that own an XT1200 resort tell me the width of the bottom of the sled. Their website states 84″ wide but that up top not the foot print width.
    I’M challenged for space and need to know before I buy. Thank you! !! Bob

    hamms
    Mn
    Posts: 493
    February 14, 2015 at 2:45 pm #1511589

    Don’t you need to allow for that much space if that is what the top is? Not fully understanding your question I guess. You’re wanting to know the on ice measurement?

    Kent Tau
    Posts: 205
    February 14, 2015 at 4:15 pm #1511616

    If you need it as references to see if it will fit your truck.. 84″ is the length I believe. I have the lodge and it wouldn’t fit my 6.5 foot bed truck once its assembled. I have to lift the back and rest it on the tailgate then close it.

    nblasius
    SE South Dakota
    Posts: 53
    February 14, 2015 at 5:51 pm #1511628

    I have the resort. Think of it as a four by eight sheet of plywood in the shape of a bathtub! It is a phenomenal shelter but if you don’t have a trailer, go smaller! Also don’t try to hand pull it. That’s why they make smaller ones! I also have the cabin and the cottage they are more practical for solo trips.

    benelli-bob
    Eagan, MN
    Posts: 311
    February 14, 2015 at 6:43 pm #1511636

    Nb
    I hear you loud and clear. I will be using my Can Am Commander X to pull it. I have plenty of HP to pull it.

    I have a trailer that the manufacture claims is 79″ wide with a lip on each side. I will measure it but it would be sweet if the resort would fit length wise on the trailer width. I am assuming with the angle of attack that the base is not as much length as stated on the web site. I tried to call Otter but customer service could not answer the question. I cant find any in stock any where to measure my self. If any of you that own one could at you convenience provide me the length of the bottom base that touches the ice I would greatly appreciate it.

    Otter states the collapsed dimensions are 84″L x 44″D x 22″H. Im just hoping the base or floor is 79″ or less

    Thanks
    Bob

    prospector
    Wyoming
    Posts: 118
    February 14, 2015 at 6:57 pm #1511643

    From back of sled to front curve is 69″. Back of sled to clear tow hitch is 75″. Do you have rails on your trailer?

    benelli-bob
    Eagan, MN
    Posts: 311
    February 14, 2015 at 7:24 pm #1511650
    prospector wrote:

    From back of sled to front curve is 69″. Back of sled to clear tow hitch is 75″. Do you have rails on your trailer?

    Joe
    Thanks it should fit!!!! I would go buy one now so I could start to “pimp” it out this summer but can find any. So I will be first in line in the fall
    Thanks again I really appreciate it.
    Bob

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.