Need help with a troll master on Yamaha 15hp

  • Randy Wieland
    Lebanon. WI
    Posts: 13651
    June 22, 2024 at 12:37 pm #2278086

    Anyone on here have a troll master specifically on a Yamaha 15hp. Having issues with the cam not returning to low idle and clearance to the cowling. Tech support wasn’t any help

    Randy Wieland
    Lebanon. WI
    Posts: 13651
    June 22, 2024 at 8:14 pm #2278118

    That was a test run I did. The install guide from Troll Master is way off. Their suggestion on install doesn’t fit or work. I just did a complete delete of the tiller and linkage. Found a better place to mount the servo that fits in the cowling. Down fall is it can be started in gear or can shift at high rpm. Otherwise, works awesome

    mark-bruzek
    Two Harbors, MN
    Posts: 3875
    June 22, 2024 at 8:23 pm #2278119

    Make sure the wires for the servo are not near any spark plug wires, they will pick up stray induction electriciry and make the servo hold higher levels of throtttle.
    Also any extra wire should be wrapped in fig 8 shape rather than a circle coil.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.