Minn kota Ulterra trim collar height

  • Dusty Gesinger
    Minnetrista, Minnesota
    Posts: 2417
    April 3, 2020 at 7:09 am #1930367

    How tall is the trim collar on the ulterra? Trying to figure out how much shaft length I would lose going to a ulterra. Does anyone have the riptide version in 54″ can the foot peddle be added to it?

    Dutchboy
    Central Mn.
    Posts: 16654
    April 3, 2020 at 8:33 am #1930379

    I’m not following. Ulterra has a power shaft. You can trim it up or down with the buttons.

    SuperDave1959
    Harrisville, UT
    Posts: 2816
    April 3, 2020 at 8:57 am #1930384

    Was mentioned on another post a few days ago, 5″ – 6″, when I bought mine, I bought the same shaft length as my old motor which never had a problem with rough water. This motor comes out of the water more often due to the shaft length loss.

    Dusty Gesinger
    Minnetrista, Minnesota
    Posts: 2417
    April 3, 2020 at 9:20 am #1930395

    Thanks, so probably 3″ bigger than the terrova collar if anyone has had both?

    Dusty Gesinger
    Minnetrista, Minnesota
    Posts: 2417
    April 3, 2020 at 9:21 am #1930399
    Dutchboy wrote:

    I’m not following. Ulterra has a power shaft. You can trim it up or down with the buttons.

    The collar on the shaft that does the trimming. It only allows the motor to trim down so far trying to figure out how much you lose.

    David Blais
    Posts: 766
    April 3, 2020 at 9:59 am #1930416

    The terrova has lift assist and I think you loose more with that

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.