Minn Kota Riptide 70LB Thrust Prop wants to turn but wont

If you caught some line into the prop shaft i cut the seal and leaked water into the housing… its now frozen and the armature won’t spin.

Take the prop off and check the shear pin and remove any line or debris. If the shaft still does not spin, it is probably something inside the motor such as bad or dislodged brushes. I ruined the rear thrust bushing on a Minnkota by driving the boat around with the MK in the water. Prop shaft had enough back and forth play that the brushes disengaged from the armature. Fixed it myself.

Hey guys thanks for the info. So I pulled the lower unit apart looks like I did get water in it. One of the brushes is blown apart. My question now is do I need to replace the piece that holds the brushes or should I be able to just clean it up and put in new brushes? I’ve attached a picture. Thanks.

Attachments:

1. 

   16142087463066882689296837135840.jpg
   

not sure if you can get just the brushes, clean up the plate and see what it looks like if good and can get just the brushes go with that.