Lund Boat–adding a bow mount fish finder

  • Dave A
    Posts: 2
    #1939619

    I’m installing a bow mount fish finder on my 2015, 2025 Lund Impact. I think I found the wire Lund left up in the bow compartment that should be for the bow mount fish finder. My question is where is the other end that is supposed to go to the battery? Is it already connected at the battery and just needs a fuse? How does this work? Thanks!

    Attachments:
    1. 20200229_164342.jpg

    Palerider77
    Posts: 630
    #1939621

    If there are two wires, one would be a ground and the other power. Try the accessory switch on the panel, should give you power. Otherwise there should be rigging tubes under the floor that you can pull wire through to your battery. Use your multimeter to verify power.

    Dave A
    Posts: 2
    #1939628

    Thank you! That’s really helpful!

    hillhiker
    SE MN
    Posts: 1029
    #1939634

    If there was a spare set of wires left at the bow for a graph you likely have a open fuse spot in your main fuse block at the helm. You should be able to look at the wire colors to figure out which spot it is.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.