HDS Ethernet sharing question

after just watching Doc’s video, I looked more into the sharing waypoints, routes, etc.

With using the Ethernet ports for the LSS, will that still enable me to share all that information?

Yes.

More HDS info

Well as I was looking though the manual today….again and also talked to a pro staffer at the sports show, I do believe I found out the answer.

If you hit [enter] twice it will create the way-point on that unit only. If you hit [WPT] twice it will create it on both units.

If you have 4 units will you need to hit “WPT” 4 times??

Quote:

---

Well as I was looking though the manual today….again and also talked to a pro staffer at the sports show, I do believe I found out the answer.

If you hit [enter] twice it will create the way-point on that unit only. If you hit [WPT] twice it will create it on both units.

---

Whichever way a waypoint is saved it will be saved
to all the units that are connected via ethernet.

This could be a unit to unit connection, 3 units connected
through the StructureScan, or more than 3 through an
expansion port with StructureScan or without.

You don’t have to save a waypoint a certain way to save
to all units.

Somebody was shooting from the hip!!

Dandorn has it correct but I do not have the Lss. I have 2 HDS units networked with the ethernet and does not matter which way I put in a waypoint it is automatically on both units.

Thanks guys, I goofed up the settings on the one unit that is why I wasn’t seeing them. I did a reset and then the waypoints showed up.