LSS-2 no source?

  • ib_jigged
    Posts: 45
    #1307277

    I bought a LSS_2 unit to add to my Gen 1 HDS 5 and 7 and everything worked fine on both units until tonight.

    I went to go fishing and when I turned on my HDS7 I get no source on the SS window on the screen. I look at my LSS-2 box and the power light is on, the sonar light blinks, and the unit 1 or 2 light will light up depending on which unit is powered up.

    I connected all 3 yellow wires together from the three units so I could control the power to the SS unit with the power buttons on the HDS units.

    The LSS-2 units is recognized in the menu as being there, I just don’t get any data on the screen, just the words “NO SOURCE” when powered on and water temp, no depth reading and a scale of 5′.

    What could be wrong?

    Ken Sauret
    Paso Robles, California
    Posts: 164
    #1180688

    Check your cable and connection from the transducer to the module. Is your Ethernet network is working properly. It sounds like your module is alive, but I want to be sure.

    I think this is a transducer problem. If the Ethernet is sending information across the network but you are getting a ‘No Source” then the transducer isn’t talking to the module.

    If the ethernet is working properly and there are no problems with the LSS-2 transducer connections or kinked or pinched cable then you may need to call Lowrance Customer Care for further assistance. 1-800-628-4487

    ib_jigged
    Posts: 45
    #1180862

    Contacted Lowrance and they want me to send back the box and the transducer.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.