332 c can i use it with hds

  • wismitty
    Janesville wisconsin
    Posts: 149
    March 27, 2013 at 6:44 pm #1307210

    I have a lms 332c and a lms 480 laying around how and can I hook them up with my current hds units?

    bassn7
    Bruce,WI
    Posts: 776
    March 27, 2013 at 6:54 pm #1156682

    if they have a nema 2000 port they will share way points my LMS520C does and i have it hooked up w a HDS 7&8 also has a yellow ethernet hook up and shares depth finder and uses the HDS GPS antena too!
    Stan

    wismitty
    Janesville wisconsin
    Posts: 149
    March 28, 2013 at 12:07 am #1156798

    Thanks

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 28, 2013 at 12:46 am #1156827

    Did you have too change any settings to get it to work or just plug them in? I have a HDS7 and LMS 522C and I can’t get it to share the Sonar.

    bassn7
    Bruce,WI
    Posts: 776
    March 28, 2013 at 2:00 am #1156865

    Go to sonar page on the HDS7 and tell it to share the sonar signal , I just moved the transducer from LMS TO THE HDS so I didn’t have to pull a new transducer cord. both are on the nema 2000 and eathernet tru the LSS1.
    Stan

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 29, 2013 at 12:26 am #1157182

    Are you talking about checking on the Network Sonar Box? I don’t know where it says share sonar. Checking the network sonar box didn’t work so I am thinking either the ethernet jack on one of the units is bad or the ethernet cable is bad.

    bassn7
    Bruce,WI
    Posts: 776
    March 29, 2013 at 3:09 am #1157088

    yes if you turn on share sonar then my LMS could see the sonar the manual says thru eathernet.its on page 80 of the manual.I’ll be putting everthing back in the boat this weekend as I don’t leave it in the cold garage all winter,and Ill start things up and see what I have on for sure.

    Stan

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 29, 2013 at 3:14 am #1157216

    I turned it on yesterday while out on the water the HDS said 10 ft the LMS didn’t have a reading. Something isn’t right with one of the units. I found what you referrenced on page 80 and it is what I did. I guess I will have to get Universal sonar on my PDV2.

    wismitty
    Janesville wisconsin
    Posts: 149
    March 30, 2013 at 8:35 am #1157544

    No Ethernet on 332c I bought 127-05 red to blue connector and new power node. Sonar works fine.Sharing ducer.

    honest_john
    Twin Cities, Minn.
    Posts: 90
    March 30, 2013 at 4:36 pm #1157613

    I don’t understand. How do your hds unit, your 332 and your 480 share a transducer???

    bassn7
    Bruce,WI
    Posts: 776
    March 30, 2013 at 7:57 pm #1157663

    My HDS shares w LMS520 C the HDS has the transducer hooked up to it and the LMS sees what ever the HDS is showing!
    Stan

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    April 2, 2013 at 1:24 am #1158265

    I believe it only works for the sonar, you can not shard the GPS between the two units. Correct me if I am wrong because that happens often.

    wismitty
    Janesville wisconsin
    Posts: 149
    April 2, 2013 at 11:19 pm #1158645

    zach Yep only sonar

Viewing 13 posts - 1 through 13 (of 13 total)

You must be logged in to reply to this topic.