522C and HDS7

  • zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 17, 2013 at 9:20 pm #1307201

    I just purchased a used 522C and I want to run my chart on the HDS7 and my graph on the 522C. Can I connect them with an ethernet cable or network cable and run it like this or do I have to set up each one separately?

    dandorn
    M.I.N.N.E.S.O.T.A.
    Posts: 3211
    March 17, 2013 at 9:50 pm #1153121

    You can run them separate unless you want to share saved waypoints between the two.

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 17, 2013 at 9:56 pm #1153124

    I don’t have the transducer for 522C will the HDS transducer work or do I need to get one for the 522C?

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 17, 2013 at 10:08 pm #1153127

    Also if the two units are connected via ethernet cable will they each show the same thing(if i have the sonar page on one will it have the sonar page on the other), or can I have the sonar page on one and the chart on the other?

    dandorn
    M.I.N.N.E.S.O.T.A.
    Posts: 3211
    March 17, 2013 at 10:19 pm #1153129

    Yes your HDS tranducer will work with the LMS unit.

    You can view the sonar on the HDS via ethernet or you can
    set it to the chart page.

    Mapping data is not shared between the two.

    wismitty
    Janesville wisconsin
    Posts: 149
    March 26, 2013 at 10:30 pm #1156423

    Is this in 2d only???? I have an lms 332c just sitting around, What do I need to hook it up to my hds7? Can I use it for depth etc?

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 28, 2013 at 12:48 am #1156828

    I can’t get it to work either way, I must be doing something wrong.

    dandorn
    M.I.N.N.E.S.O.T.A.
    Posts: 3211
    March 29, 2013 at 12:47 pm #1157287

    Zach,

    Make sure your 522c is running the 2.5 software version.

    I think this update was needed for ethernet capabilities.

    Dan

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    March 30, 2013 at 3:09 am #1157519

    I did just that and guess what happened…IT WORKED!!! Thanks for all the help and advice I am sure I will be back here with more questions soon. Thanks again!!

    zach_bindert
    Cedar Falls, Iowa
    Posts: 94
    May 30, 2013 at 1:17 am #1174263

    I have a map chip I bought in 2012 works great in the HDS7, but I can’t get it to work in the LMS 522C. I tried changing the navionics data, but the only option is Lowrance. Am I looking in the right place? How do I get it to work or is the chip too new?

    Thanks,

    Zach

Viewing 11 posts - 1 through 11 (of 11 total)

You must be logged in to reply to this topic.