Please confirm that I’m on the correct assumptions please. Fill in where I fell off too.
I have a ’07 Suzuki DF60 that I want to run with my new Garmin 546S. So all I should need is the Garmin starter kit correct? That will allow my gauges to be displayed one way or another on the Garmin 546s, correct? Thank you in advance.
I’m not sure about the Garmin’s but I just did this from my Yamaha F150 to my HDS 7. I needed the NMEA starter kit and the CommandLink cable that connects to the motor. In my case this was the setup: Cable from motor to a network T connected to another network T that was connected to power then another T that connects to the head unit followed by the terminating resitor. The cable for your motor should come with one T and the starter kit has two I believe. Hook up to power and ground (at least on the HDS) and you should be all set.
Hope that helps.
You must be logged in to reply to this topic.
