livewell & bilge electrical connectors – 07 ranger

  • ______________
    Inactive
    MN - 55082
    Posts: 1644
    April 7, 2015 at 6:58 pm #1532117

    I’m replacing all my water pumps. I have the new pumps, but need to get the right electrical connectors. Anyone know what these are called?

    Attachments:

    1. 14284511247561048385121.jpg

    2. 1428451163655-695330864.jpg

    3. 1428451188816666599746.jpg

    TheFamousGrouse
    St. Paul, MN
    Posts: 11662
    April 8, 2015 at 11:54 am #1532347

    Can’t you cut the connectors off the old pumps? Use waterproof crimp splices to attach them to the new pump wires and then heat shrink over the top as extra protection.

    Grouse

    Matt M
    Blaine, MN
    Posts: 169
    April 8, 2015 at 3:21 pm #1532430

    Wow. Unbelievable. I am currently doing the same thing to my 2007 ranger. I have replaced both aerator pumps and now the bilge. I looked everywhere for the exact clips and can’t seem to find them. I did as grouse suggested and it has worked fine. Going to do the same with the bilge wire. If anyone knows where to get the clips I would also like to know since it would be a lot less likely to fail with less joints.

    Matt

    ______________
    Inactive
    MN - 55082
    Posts: 1644
    April 8, 2015 at 8:31 pm #1532545

    Thanks guys, for now I cut and spliced as suggested.

    The Google heavily implied these connectors are Ranger specific, likely only available through their dealer network.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.