Lindy jig PSA

  • Deuces
    Posts: 5236
    #2234625

    Buddy up nort had some complaining about some jigs bending on him at leech not long ago and have had poor quality in the past w northland jigs, fast forward this weekend w some fuzzegrubs that bent on couple hooksets, thought maybe they were snags but after 3rd one grabbed the hook and sure enough could bend it any which way I wanted w ease. Frustrating.

    Check ur hooks so u don’t lose that big fall fish! Tight lines

    Edit: jigs were bought from one-stop in longville, not many places carry them anymore!

    Attachments:
    1. 20231107_194436-1-scaled.jpg

    2. 20231107_194436-scaled.jpg

    Rodwork
    Farmington, MN
    Posts: 3975
    #2234659

    That is frustrating. Do you think it is a bad batch where the hooks missed the heat treatment or the product just has gone downhill?

    Deuces
    Posts: 5236
    #2234665

    Bad batch, seen it b4 5yrs ago w northland jigs.

    Doesn’t seem like lindy even has a site anymore, didn’t Google too hard but it goes right to distributor sites.

    mrpike1973
    Posts: 1505
    #2234673

    Bought some Northland jigs this year had good luck with them. Had the same issue a few years back they would snap in half.

    bigcrappie
    Blaine
    Posts: 4330
    #2234674

    Chinses knock off, there is fake line also floating around. They knock off everything.

    Deuces
    Posts: 5236
    #2234677

    You think a retailer would get knockoffs?

    Rodwork
    Farmington, MN
    Posts: 3975
    #2234679

    You think a retailer would get knockoffs?

    If it is cheaper (better profit margin) and looks the same they might. If they knew about the hook problem they may not.

    TillrLife
    Cold Spring, MN
    Posts: 891
    #2234688

    Bad batch, seen it b4 5yrs ago w northland jigs.

    Doesn’t seem like lindy even has a site anymore, didn’t Google too hard but it goes right to distributor sites.

    PRADCO owns Lindy, among many other outdoor brands.

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.