Kicker install on MX1825

  • HMoshier
    Posts: 108
    #2155860

    I picked up a used 8HP Honda while in FL. I plan on using it but don’t plan on making a permanent install at this time. I’d like to find a couple plates to protect the gel coat from the clamp screws and bracket. Does anyone have a setup like this? Any recommendations on what I can use to protect the transom for temporary installs? Thanks.

    Dutchboy
    Central Mn.
    Posts: 16650
    #2155862

    My first thought would be to cut up a inner tube from a car tire.

    Dean Marshall
    Chippewa Falls WI /Ramsey MN
    Posts: 5854
    #2156779

    We had metal transom brackets made for kicker applications. Give either store parts dept a call for more intel. Dan at Ramsey or Colin at Chippewa.

    HMoshier
    Posts: 108
    #2156893

    We had metal transom brackets made for kicker applications. Give either store parts dept a call for more intel. Dan at Ramsey or Colin at Chippewa.

    Thanks, Dean. I recall one of the guys at the Chippewa store telling me that when we stopped in back in June 2021. Hopefully, the showroom floor is more full now than it was then.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.