Changing hole size on an Eskimo auger

  • jhierlinger
    Lauderdale, MN
    Posts: 93
    December 17, 2009 at 4:21 pm #1300788

    I don’t want to buy a new auger, but I want a smaller hole drilled. So I am wondering if if it possible to downsize from an 10in to an 8 in with an eskimo auger.
    John

    Scottyb
    Clinton Iowa
    Posts: 4
    December 17, 2009 at 4:31 pm #824169

    I’m “pretty sure” that you can. Check out the Eskimo web site they should have info there.

    Brent Yeakey
    Bloomer, WI
    Posts: 553
    December 17, 2009 at 4:39 pm #824174

    I would contact Strikemaster, but I believe you can run a Laser shaft on an Eskimo Power head.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.