Eskimo Won’t Idle

  • grpubl7
    Central WI
    Posts: 277
    January 18, 2016 at 11:01 pm #1593680

    Roger that…TYVM

    grpubl7
    Central WI
    Posts: 277
    January 20, 2016 at 9:57 am #1594038

    FYI…

    Spoke directly with Eskimo support and they confirmed what milemark_714 stated. They advised to bottom out the air/fuel screw on the carb body and back off 1-3/4 turns as the factory setting. Adjust from there in 1/4 turn increments when engine is warm.

    I then adjusted the screw that acts directly on the throttle and got my idle where I wanted it.

    Interestingly, they claimed that when freezing cold and on the first start, they recommended depressing the throttle slightly when pulling over. Did that after it sat out in -15F temps overnight and it started on first pull ;)

Viewing 2 posts - 31 through 32 (of 32 total)
1 2

You must be logged in to reply to this topic.