lazer Mag solo issues!

  • Walleye-Willie
    Minnesota
    Posts: 7
    January 10, 2014 at 10:30 am #1359580

    Anyone else do a carb kit on there solo.
    Pretty easy mine had a bad diaphragm
    So I changed that and the other gaskets and the needle.
    Runs like new again.

    vikefanmn77
    Northfield,MN
    Posts: 1493
    January 10, 2014 at 10:51 am #1378830

    Sooo glad I’ve stayed away from that solo engine!

    duke.harbaugh
    Posts: 207
    January 10, 2014 at 11:28 am #1378843

    Quote:

    Sooo glad I’ve stayed away from that solo engine!

    Nothing to do with the engine. Stay away from ethanol… have never ran a drop of ethanol in mine and it runs like a top… sounds like a common issue in boat motors as well… lOo

    icenutz
    Aniwa, WI
    Posts: 2540
    January 10, 2014 at 5:31 pm #1378941

    I’m on my 3rd year with my solo and it runs as good as the day I bought it.

    vikefanmn77
    Northfield,MN
    Posts: 1493
    January 10, 2014 at 10:13 pm #1378962

    Im sure there are some good ones out there, but seems that there are issues brought up on sites like this on a weekly basis with them. Still better than a Jiffy I guess…

    Poorboy
    Illinois
    Posts: 47
    January 11, 2014 at 3:02 am #1378969

    Did you buy your parts directly from Strikemaster?

    I’ve been using the VP Fuels 40:1 Premix from Home Depot and I can say my auger has been running a hell of a lot better! The Ethanol additive makes any motor run like crap ….

    Walleye-Willie
    Minnesota
    Posts: 7
    January 11, 2014 at 8:44 am #1378983

    It was because of the gas forsure i switched using the non-oxygenated gas runs great.
    But i think there venting system could use alittle work or some other design.sucks when you have to loosen the gas cap to vent.
    Other than that they rip thru the ice.

    vikefanmn77
    Northfield,MN
    Posts: 1493
    January 11, 2014 at 3:59 pm #1379034

    Coincidence? Out this morning with my buddy. He drills 12 holes and all the sudden…nothing! Motor runs and revs, but does not engage or spin! Guess what he has???

    Randy Wieland
    Lebanon. WI
    Posts: 13661
    January 11, 2014 at 4:03 pm #1379036

    Quote:

    Coincidence? Out this morning with my buddy. He drills 12 holes and all the sudden…nothing! Motor runs and revs, but does not engage or spin! Guess what he has???


    Hand Auger

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.