I am trying to replace my muffler guard on the mag 10″ auger with the Solo engine. there is a screw located on the bottom which i am unable to get at unless I take the lower half of the unit off. If I do that, I’m assuming i will be exposing the guts of the drive shaft bearings and what not (i don’t want to F anything up). Is there a better way to do it or a tool out there that can get in to the small space with a 90* angle? thanks,
Quote:
I am trying to replace my muffler guard on the mag 10″ auger with the Solo engine. there is a screw located on the bottom which i am unable to get at unless I take the lower half of the unit off. If I do that, I’m assuming i will be exposing the guts of the drive shaft bearings and what not (i don’t want to F anything up). Is there a better way to do it or a tool out there that can get in to the small space with a 90* angle? thanks,
Nope that is the only way in. There is actually two screws you will have to back off. It’s not that big of a deal if you are mechanically inclined. Lube the gears while you have it apart. I can walk you through it piece by piece if need be.
I will give it a shot this weekend and let you know. As long as i don’t have things falling out once i get it apart i should be able to get it done!
You must be logged in to reply to this topic.
