Auger help (Burnsville Area)

  • TroyRozeske
    Burnsville MN
    Posts: 208
    February 9, 2012 at 12:34 am #1303602

    Does anyone know of anyone in the Burnsville area that works on ice augers, or small engines. My Strikemaster started dogging really bad lastnight. It has been running really good up until last night, drilled 2 holes fine, then wouldn’t idle or stay running unless you keep on the throttle. Please help

    Mike W
    MN/Anoka/Ham lake
    Posts: 13310
    February 9, 2012 at 12:54 am #1036836

    Might want to try a new plug if it hasnt been changed in a while. New gas if its old. Check the easy stuff first.

    biggill
    East Bethel, MN
    Posts: 11321
    February 9, 2012 at 12:58 am #1036837

    Ya, try the gas and plug thing. I spent a week rebuilding my carb, and giving my whole auger a good cleaning only to find out that it still wouldn’t run. A new tank of gas was all it needed.

    roosterrouster
    Inactive
    The "IGH"...
    Posts: 2092
    February 9, 2012 at 2:14 am #1036878

    X3! 9 outa’ 10 times its bad gas…RR

    mfreeman451
    Posts: 543
    February 9, 2012 at 5:13 am #1036926

    Hey Troy,

    Try Rosemount Saw and Tool in Rosemount, MN. I’ve had auger work done there in the past and they should probably have a good turnaround time this late in the season.

    Jack Naylor
    Apple Valley, MN
    Posts: 5668
    February 10, 2012 at 1:01 am #1037329

    Quote:

    Try Rosemount Saw and Tool in Rosemount

    They are just north of 42 and 3, on 3, just past the gas station on the right, with all the snow blowers in the front.
    Jack

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.