So i was towing my clam guide out on the river on sunday and noticed a good amount of snow coming into my house. i later found a 1 inch slit in the back corner of my sled.
What would you guys recommend using to patch this up? talking with Grant today, he suggested bed liner, but i was also thinking trying to melt some plastic into the cut. any suggestions?
This is what I came up with…..http://www.urethanesupply.com/kcwelder.php, or you could use a real good epoxy?! Hope I helped!
Look up ( three bond plastic repair kit ) works great on atv plastic
Quote:
Look up ( three bond plastic repair kit ) works great on atv plastic
X2 on the three bond
Also once you patch the hole you may want to think about investing in some hyfax runners. You can always check local snowmobile salvage yards and shops most places will give them to you.
Depending the sized of the hole a two part epoxy will do just fine. Just scuff up the plastic where the epoxy will bond to. this will insure a better hold
JB Weld
or if you’re a Red Green purist
“Duct Tape” the handyman’s secret weapon
You must be logged in to reply to this topic.
