Ice sled repair question

  • erod61
    Posts: 45
    January 2, 2012 at 9:56 pm #1303295

    This may be a totally dumb question. I have an older Fish Trap that has a couple of small holes in the base of the sled near the end of the “runners”. What can I use that will stick to the plastic to repair the holes? Right now it picks up snow, pebbles,dirt etc. Am I stuck just putting a sheet of plastic across the bottom?

    icenutz
    Aniwa, WI
    Posts: 2536
    January 2, 2012 at 9:58 pm #1023553

    I saw a post on some website about an epoxy type stuff that is supposed to stick to anything. Now I just need to remember what it was!

    dan stien
    Waunakee, Wisconsin
    Posts: 400
    January 2, 2012 at 10:24 pm #1023569

    You could try JB Weld, make sure to roughing up the surface first.

    bret_clark
    Sparta, WI
    Posts: 9362
    January 2, 2012 at 10:28 pm #1023571

    I repaired one using epoxy to fill the hole and then put on hyfax runners. It worked great.

    taz
    Frederic wi
    Posts: 395
    January 2, 2012 at 10:48 pm #1023579

    Try useing three bond plastic repair kit. I have used it to fix broken plastic on my four wheeler and works great.

    erod61
    Posts: 45
    January 2, 2012 at 11:50 pm #1023611

    Thanks fella’s I have a direction to go now! E.

    BBKK
    IA
    Posts: 4033
    January 3, 2012 at 12:13 am #1023622

    Devcon plastic weld is what you want.. epoxy wont stick to it.

    bret_clark
    Sparta, WI
    Posts: 9362
    January 3, 2012 at 12:09 pm #1023793

    Quote:

    Devcon plastic weld is what you want.. epoxy wont stick to it.

    Someone should tell the epoxy I used that

Viewing 8 posts - 1 through 8 (of 8 total)

You must be logged in to reply to this topic.