spring on throttle of eskimo 8900

  • mroberts
    Nebraska
    Posts: 103
    #1302694

    I have an old Eskimo 8900 model. I had to clean the carb up due ti it being all gummed up. I put it back on and got the springs hooked back up for the throttle. When it is not running it opens wide up. When i start it up and pull the handle all the way to wide open it does not run all the way open. Do I need a new spring or is it hooked in the wrong place.

    morey shay
    Posts: 29
    #998022

    if it was working right before its prob hooked wrong
    good luck

    mroberts
    Nebraska
    Posts: 103
    #998077

    Well I moved the spring and it ran wide open for a very short time then goes back to not quit running wide open. I think the spring must be wore out.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.