I had a problem using a Duracell SD chip in the Bushnel
camera. I could format the chip but no pictures will
store on it for some reason. I could put the San-disk SD
chip back in and pictures will save to that chip. So I
tried the Duracell SD chip and again it will format OK, but pictures will not save to it. This were both 2GB chips. I ended up not getting any pictures for a 2 week
period because of this. So any time a new SD card is put
in the camera go into Setup mode and take a picture to make
sure it is saved. Other then this the camera has worked good.
jessica011
Posts: 13
September 1, 2009 at 1:18 pm
#205954