he must not have read the instructions

  • absolute2ks
    Chippewa Falls, WI
    Posts: 674
    #205162

    I hope this works this time

    Sighting in your new Deer rifle
    1. Shiny new, high-powered deer rifle………….. $1200.00
    2. Quality, high-powered scope…………………… $550.00
    3. Bore sighting device……………. ………………… $140.00
    4. Hospital Visit……………………………………….. $4,893.00
    5. Forgetting to remove the bore sighting device prior to shooting? Priceless !

    OUCH




    Pete Bauer
    Stillwater, MN
    Posts: 2599
    #9514

    Oh WOW!

    jonboy
    Wausau, WI
    Posts: 445
    #9545

    OUCH!

    pahaarstad
    metro
    Posts: 712
    #9170

    That is going to leave a mark.

    col._klink
    St Paul
    Posts: 2542
    #8881

    Give ya a C-note for the scope………….

    phishirman
    Madison, WI
    Posts: 1090
    #7670

    took me a minute to figure out what that forth pic was….looks like it dang near turned his face into hamburger

    deertracker
    Posts: 9253
    #7886

    I knew there was a reason why I use a bore sighter that you chamber like an actual round, OUCH!

    Tribepride
    Mahnomen, Mn
    Posts: 16
    #21474

    I watched Myth Busters when they tried to replicate that picture and the most they were able to do was get a small bulge in the barrel. They even shoved the gun barrel into dirt to pack it tight and nothing happened. I also believed they lightly welded something to the end and couldn’t get it to banna peel. After watching that episode I don’t know if I am sold on that picture be truthful.

    James Holst
    Keymaster
    SE Minnesota
    Posts: 18926
    #21477

    I saw that same episode. About all that happened was the barrel would blow out just “upstream” from the obstruction. Some times it would blow out a side of the barrel. Other times the barrel would just blow off right at the obstruction.

Viewing 10 posts - 1 through 10 (of 10 total)

You must be logged in to reply to this topic.