How are folks aligning holes for 2-3 people in a 8×8 hub shack to see as many of the lines as possible with a Livescope? Where do you sit, fish holes, and put the livescope hole? I understand depth will be a factor with seeing lines. I also have a second screen and network cable so we could have two screens connected. Great….more gear to haul 
If you use forward facing and not straight down and put the unit close to one end of the shack you might get all if at 20′ or deeper. It is 20 degrees wide and 135 degrees long and at 20′ deep it will be 7.1 wide. If straight down then the center might be better because of the 7′ radius.
Best way would be to drill the holes rental shack style like you would see on lake of the woods. All in one line down the center. Personally Id do 4 holes in a line down the center for the live scope and jigging rods, and then do 1 hole in each corner for a rattle reel or deadstick set up. This way you can all utilize the live sonar but still run 2 lines.
Interesting…. What is the formula or how do you figure out how much circular area you will see on LVS34 in down mode for particular depths? If in 20 feet of water I can see a circle of what dimension?
7.1 feet and the shallower will make the diameter smaller. Deeper it will get larger.
You must be logged in to reply to this topic.
